Suzuki Baleno Manual page 672

7B-102 AUTOMATIC TRANSMISSION (3 A/T)
1. Washer
A: Groove
B: Protrusions to be engaged in drum
grooves C
1. Ring gear race (OD: 35.8 mm/l .41 in.)
2. Bearing
3. Ring gear race (OD: 37.9 mm/l .49 in.)
30) Apply grease to direct clutch washer, and install it on direct
clutch with its grooved face outward and aligning washer pro-
trusions to direct clutch drum groove.
"A": SUZUKI SUPER GREASE C, 99000-25030
31) Align teeth of direct clutch discs and then install direct clutch
on input shaft.
After installing direct clutch, check it for proper installation by
moving it up and down lightly by hand. If direct clutch makes
clear sound like "Click" when move up and down, it is installed
in place. But if no sound or thick one is heard, it is possible that
direct clutch is not installed correctly. In such case, remove di-
rect clutch and reinstall.
32) Apply grease to ring gear races and bearing.
Install ring gear race (OD: 35.8 mm/1 .41 in.) on ring gear with
its flange side down. Another ring gear race (OD: 37.9
mm/1.49 in.) and bearing are attached on input shaft.
Refer to "ASSEMBLING UNIT" in this section for proper instal-
lation.
"A": SUZUKI SUPER GREASE C, 99000-25030
33) Install input shaft and forward and direct clutch assemblies.
Hold input shaft with direct clutch installed by hand and while
turning it back and forth, insert it into case.
Align teeth of forward clutch discs before installation.
When installing input shaft, be careful so that its bearing and
race will not fall off.
Be careful not to damage output shaft seal.
After installing input shaft, check it for proper installation by
moving it up and down lightly by hand. If input shaft makes
clear sound like "Click" when moved up and down, it is installed
in place. But if it doesn't, try again for proper installation.