Manual Selector - Suzuki Baleno Manual

7B-60 AUTOMATIC TRANSMISSION (3 A/T)
1. Selector assembly
2. Selector lever assembly
3. Indicator assembly
4. Screw
5. Knob assembly
6. Screw
7. Solenoid (if equipped)
8. Screw (if equipped)
9. Housing nut

MANUAL SELECTOR

REMOVAL
1) Remove selector knob screws and then selector knob.
2) Remove parking brake lever cover and then console box.
3) Remove select indicator assembly.
4) Remove illumination lamp coupler.
5) Remove select cable from selector lever. (if equipped)
6) Remove interlock cable. (if equipped)
7) Remove shift lock solenoid coupler. (if equipped)
8) Raise vehicle.
9) Remove 4 housing nuts.
10) Remove lever housing with selector lever from floor.
NOTE:
D Knob and push button must not be disassembled.
D Do not drive out detent pin.
INSTALLATION
Assemble selector by reversing removal procedure, replacing
parts with new ones as necessary.
Apply grease to portions indicated as "A" in left figure.
"A": SUZUKI SUPER GREASE A (99000-25010)
NOTE:
D When installing knob, make sure that there is a slight clear-
ance between detent pin and cam bottom when knob button
is pushed in all the way.
D Check selector for proper operation as follows.
1. With knob bottom pushed half way, N to R and D to 2
shifts are available (but not any other shift).
2. With knob button pushed all the way in, 2 to L and R to
P shifts are available.
D For adjustment of interlock cable, refer to "INTERLOCK
CABLE" in this Section.
D Check that illumination lamp lights when light switch is
turned ON.
Tightening Torque
(a): 20 N·m (2.0 kg-m, 14.5 lb-ft)