Suzuki Baleno Manual page 921

8-24 BODY ELECTRICAL SYSTEM
IGNITION (MAIN) SWITCH
Inspection
1) Disconnect negative (–) cable at battery.
2) Disable air bag system. Refer to "Disabling Air Bag System" in
Section 9J.
3) Disconnect main switch lead wire connectors from junction/fuse
block and air bag harness.
Checking continuity between terminals
Use a circuit tester to check the continuity at each switch position.
If any continuity is not obtained, replace main switch.
Wire color
W/G
Key Position
OUT
LOCK LOCK
ACC
IN IN
ON
START
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system. Refer to "DISABLING AIR BAG SYS-
TEM" in Section 9J.
3) Remove steering column referring to Section 3C1 of this manu-
al. And then remove steering lock/main switch from steering
column, referring to Section 3C1.
Installation
1) Install steering lock/main switch and steering column referring
to Section 3C1 of this manual.
2) Enable air bag system. Refer to "DISABLING AIR BAG SYS-
TEM" in Section 9J.
NOTE:
When installing steering column, special care must be
used for tightening sequence and each torque.
Bl B/Bl Y/B B/Y B/W B G G