Suzuki Baleno Manual page 189

1. Hole cover
1. Steering column upper cover
2. Steering column lower cover
1. Yellow connector (for air bag)
2. White connector (for auto cruise)
CONTACT COIL AND COMBINATION
SWITCH ASSEMBLY
CAUTION:
Do not turn contact coil (on combination switch) more
than allowable number of turns (about two and a half
turns from the center position clockwise or counter-
clockwise respectively), or coil will break.
REMOVAL
1) Disconnect negative battery cable at battery terminal.
2) Disable air bag system. Refer to "Disabling Air Bag System" un-
der "Service Precautions" earlier in this section.
3) Remove steering wheel from steering column shaft. Refer to
"STEERING WHEEL" earlier in this section.
4) Remove hole cover.
5) Remove steering column cover screws (3 pcs).
6) Separate upper cover and lower cover, then remove them.
7) Loosen clamp.
8) Remove band binding steering column and harness (for contact
coil and combination switch assembly).
9) Disconnect yellow connector (for air bag) and white 4-P con-
nector (for auto cruise, optional).
3. Band
4. Clamp
AIR BAG STEERING WHEEL AND COLUMN 3C1-11