Suzuki Baleno Manual page 779

1. Sun gear assembly
2. Planetary carrier 3. Planetary ring gear
36) Remove carrier for front/rear planetary ring gear and sun gear
assembly with the following integral bearing installed.
Integral bearing with race dimension
Outside diameter : 32.3 mm (1.27 in.)
Inside diameter
Race thickness
37) Pull out sun gear assembly.
38) Inspect 1st and reverse brake piston stroke.
a) Set special tools (dial gauge and magnetic stand).
Special Tool
(A): 09900-20606
(B): 09900-20701
b) Measure piston stroke while applying and releasing com-
pressed air (400 – 800 kPa, 4 – 8 kg/cm
oil hole (1).
Specified value: 1.4 – 2.2 mm (0.055 – 0.087 in.)
NOTE:
If piston stroke exceeds specification above, inspect or
replace flanges and discs.
39) Remove snap ring using flat end rod or the like.
40) Remove flange brakes "F", disc, clutch and flanges "D" and
plate brakes "P" in the following order.
F D
1. Snap ring
AUTOMATIC TRANSMISSION 7B1-95
: 19.0 mm (0.75 in.)
: 2.7 mm (0.11 in.)
P D P D P D
2
, 57 – 113 psi) from
F