Suzuki Baleno Manual page 624

7B-54 AUTOMATIC TRANSMISSION (3 A/T)
1. Cable bracket nut 3. Cable end
2. Key release cam 4. Cam boss
1. Interlock cable
2. Clamp
1. Selector lever
("P" position and pushing knob button)
2. Key release cam
3. Selector bracket
4. Cable bracket nut
5. Leaf spring
5) Remove console box.
6) Remove cable bracket nut and detach cable end from key re-
lease cam while pressing claws of release cam boss. At this
time, be careful not to cause damage to its claws.
7) Remove interlock cable.
INSTALLATION
1) Install interlock cable as shown in left figure.
2) Connect cable end to steering lock and tighten cable clamp
screw to specified torque.
Tightening Torque
(a): 2.2 N·m (0.22 kg-m, 1.6 lb-ft)
3) Shift selector to P range and with lock plate manually moved to-
ward front side of vehicle, push knob button of selector lever.
4) Under above condition, fix key release cam inserting special
tool into holes on cam and selector bracket.
Special Tool
(A): 09925-78210 (6 mm)
5) Connect cable end to key release cam.
6) With cable bracket pushed in arrow direction by spring force,
tighten cable bracket nut.
Tightening Torque
(b): 13 N·m (1.3 kg-m, 9.5 lb-ft)
7) Remove special tool. Then with lock plate of shift lock solenoid
1. Knob button
2. Key release cam
manually moved toward front side of vehicle, check that key re-
3. Lock plate of
shift lock lease cam moves smoothly by operating knob button of selector
solenoid
lever.