Suzuki Baleno Manual page 507

1. Reverse gear shift lever
2. Input shaft oil seal
3. Countershaft R bearing cup
1. Input R bearing
1. Input R bearing
2. Plate
3. Bolt
MANUAL TRANSMISSION (J18 ENGINE MODEL) 7A1-9
SUB ASSEMBLY SERVICE
RIGHT CASE
1) For installation procedure, refer to Step 1) of same item of Sub
Assembly Service in SECTION 7A.
2) Install input shaft oil seal facing its spring side upward.
Use special tool and hammer for installation and apply grease
to oil seal lip.
"B": SUZUKI SUPER GREASE A, 99000-25010
Special Tool
(A): 09913-84510
3) Install countershaft R bearing cup by using special tools and
hammer.
Special Tool
(B): 09913-75821
(C): 09924-84510-004
4) Install input R bearing by using special tool and hammer.
Special Tool
(A): 09913-76010
5) Install input R bearing stopper plate and bolt applied with thread
lock cement.
"A": Thread lock 1322, 99000-32110
Tightening Torque
(a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
LEFT CASE
1) For installation procedure, refer to Steps 1) and 3) of same item
of Sub Assembly Service in SECTION 7A.