Suzuki Baleno Manual page 652

7B-82 AUTOMATIC TRANSMISSION (3 A/T)
1. Snap ring
2. Clutch flange
5) Install discs, plates and flange in following order.
i) Plate Õ ii) Disc Õ iii) Plate Õ iv) Disc Õ v) Plate Õ vi) Disc Õ
vii) Flange
NOTE:
Before assembly, new discs should be soaked in automatic
transmission fluid for 2 hours or more.
6) Install clutch plate snap ring.
1. Flange
7) After installing clutch plate snap ring, measure height between
snap ring and clutch flange as previously outlined. If discs and
plates are new and yet out of specification, install flange of dif-
ferent thickness. The following 2 types of clutch flanges are
available as spare parts.
Height "a": 2.01 – 2.68 mm (0.079 – 0.105 in.)
Available clutch flange
size (thickness)
8) Check clutch piston for movement by blowing air through input
shaft oil hole.
CAUTION:
Apply only low pressure air, or spring seat may be
damaged.
3.00 mm/0.118 in.
g
3.37 mm/0.132 in.