Suzuki Baleno Manual page 471

1. Engine mounting LH No.1 bracket
2. Transmission
MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS) 7A-15
15) Remove engine mounting LH No.1 bracket.
16) Remove other attached parts from transmission, if any.
17) Pull transmission out so as to disconnect input shaft from
clutch disc and then lower it.
REMOUNTING
For remounting, reverse dismounting procedure.
Use specified torque as given below.
Tightening torque
G13 engine
Transmission to en-
gine bolts and nuts
G16 engine
D Engine rear mounting bracket
bolts
D Exhaust No.2 pipe to No.1 pipe
bolts
D Center bearing support bolts
D Transmission case lower
stiffener bolt
Exhaust No.1 pipe to manifold
nuts
Ball stud bolt and nut
Extension rod nut
Gear shift control shaft bolt and
nut
Stabilizer bar link nut
NOTE:
Apply grease to gear shift control shaft bushes, however, DO
NOT lubricate extension rod bush.
CAUTION:
D Care should be taken not to scratch oil seal lip with
drive shaft while raising transmission.
D Do not hit drive shaft joint with hammer when instal-
ling it into differential gear.
D Push in left side drive shaft joint fully so as to snap ring of shaft
engages with differential gear.
N·m kg-m lb-ft
61 6.1 44.0
90 9.0 65.0
50 5.0 36.5
23 2.3 17.0
60 6.0 43.5
33 3.3 24.0
18 1.8 13.0
28 2.8 20.5