Suzuki Baleno Manual page 664

7B-94 AUTOMATIC TRANSMISSION (3 A/T)
1. Manual shift shaft
2. Lower washer
3. Oil seal
4. Upper washer
5. Manual shift lever
6. Nut
7. Manual detent spring assembly
8. Parking lock pawl
9. Lock paw spring
10. Lock pawl shaft
11. Sleeve snap ring
12. Pin
13. Parking lock pawl sleeve
14. Parking lock rod
1. Nut
2. Manual shift lever
2) Install manual shift shaft and parking lock pawl.
i) Install lower washer and parking lock rod to manual shift
ii) Install manual shift shaft into transmission case, and then,
1. Manual shift shaft
2. Manual detent spring
3. Parking lock rod
iii) Install shift shaft upper washer and then manual shift lever
iv) After tightening nuts, check manual shift shaft for smooth
v) Install restrictor pin and snap ring to parking lock pawl
shaft.
manual detent spring.
Use special care so that manual shift shaft will not damage
oil seal lip when passing through it.
Tightening Torque
(a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
to manual shift shaft. Tighten lower nut first and then upper
nut.
Tightening Torque
(b): 30 N·m (3.0 kg-m, 22.0 lb-ft)
rotation.
sleeve. And then install it to case.