System Specifications Different From Abs Control Module Specifications; Dtc C1015 (Dtc 15) – G Sensor Circuit - Suzuki Baleno Manual

DTC C1013 (DTC 13) – SYSTEM SPECIFICATIONS DIFFERENT FROM ABS
DESCRIPTION
When abnormal signal is inputted to a no-used terminal of control module while running or wrong ABS hydraulic
unit/control module assembly is installed, this DTC will be set.
INSPECTION
1) Ignition switch OFF.
2) Check for proper connection from harness to control module.
3) If OK, substitute a known-good and correct specifications ABS hydraulic unit/control module assembly.
4) Recheck system.
DTC C1015 (DTC 15) – G SENSOR CIRCUIT
DESCRIPTION
2WD Vehicle
2WD vehicle is not equipped with a G sensor. When an ABS control module for 4WD vehicle is installed to the 2WD
vehicle, this DTC is set as G sensor signal is not inputted.
4WD Vehicle
While a 4WD vehicle is at stop or running, if the potential difference between the sensor signal terminal "E116-32"
and the sensor ground terminal "E116-22" is not within the specified voltage value, or if the signal voltage while
at a stop does not vary from that while running, this DTC is set.
Therefore, this DTC may be set when a 4WD vehicle is lifted up and its wheel(s) is turned. In such case, clear the
DTC and check again.
INSPECTION
2WD Vehicle
STEP
1 Substitute a known-good ABS control module for 2WD
vehicle and recheck.
CONTROL MODULE SPECIFICATIONS
ACTION
ANTILOCK BRAKE SYSTEM (ABS) 5B-21
1. Ignition switch
2. G sensor
3. ABS hydraulic unit / control module
assembly
4. ABS hydraulic unit / control module
connector of harness
YES NO
– –