Suzuki Baleno Manual page 979

8G-14 IMMOBILIZER CONTROL SYSTEM (IF EQUIPPED)
EXAMPLE: When serial data link wire is defective (Code No.83)
Malfunction
indicator lamp
Code No.83
ON
OFF
1. Data link connector (DLC)
Code No.83
3) After completing the check, turn ignition switch OFF and discon-
nect service wire from monitor coupler.
[Vehicle equipped with immobilizer indicator lamp]
1) Turn ignition switch OFF.
2) After setting cartridge to Suzuki scan tool, connect it to data link
connector (DLC) located on underside of instrument panel at
driver's seat side.
Special Tool
(A): 09931-76011 (Suzuki scan tool)
(B): Mass storage cartridge
(C): 09931-76030 (16/12 pin DLC adapter)
3) Turn ignition switch ON.
4) Read DTC according to instructions displayed on Suzuki scan
tool and print it or write it down. Refer to Suzuki scan tool opera-
tor's manual for further details.
NOTE:
D When reading DTC stored in ECM/PCM using Suzuki
scan tool, select "ECM" from the applications menu and
"SUZUKI mode" from the communication mode menu
displayed on Suzuki scan tool.
D If ECM/PCM detects a trouble in both engine and emis-
sion control system and immobilizer control system, Su-
zuki scan tool indicates trouble codes of both systems
using Suzuki mode of ECM application.
If communication between Suzuki scan tool and ECM/PCM is
not possible, check if Suzuki scan tool is communicable by con-
necting it to ECM/PCM in another vehicle. If communication is
possible in this case, Suzuki scan tool is in good condition. Then
check data link connector and serial data line (circuit) in the ve-
hicle with which communication was not possible.
5) After completing the check, turn ignition switch OFF and discon-
nect Suzuki scan tool from data link connector (DLC).
Code No.83
Time (sec.)