Suzuki Baleno Manual page 508

7A1-10 MANUAL TRANSMISSION (J18 ENGINE MODEL)
1. 5th gear spacer
2. L bearing (Install it first)
INPUT SHAFT ASSEMBLY
Disassembly
1) Remove input shaft R bearing spacer and circlip.
2) For disassembly procedure, refer to Steps 2) to 7) of same item
of Sub Assembly Service in SECTION 7A.
Inspection and Reassembly
1) For inspection and reassembly procedure, refer to Steps 1) to
4) of same item of Sub Assembly Service in SECTION 7A.
2) Drive in R bearing spacer by using special tool and hammer.
Special Tool
(A): 09913-80112
3) Install circlip to input shaft.
4) For inspection and reassembly procedure, refer to Steps 6) to
8) of same item of Sub Assembly Service in SECTION 7A.
1. R bearing
spacer
2. Input shaft
5) Press-fit L bearing by using special tool and hammer.
Special Tool
(A): 09913-80112
6) Using the same special tool, drive in 5th gear spacer.
CAUTION:
To prevent 5th gear spacer from being distorted be-
cause of excessive compression, do not press-fit it
with L bearing at once.