Suzuki Baleno Manual page 241

3E-18 REAR SUSPENSION (2WD VEHICLE)
1. Flare nut
2. Bleeder plug cap
INSTALLATION
1) Install rear knuckle to strut, and connect control rods and trail-
2) Tighten strut bracket bolts and nuts to specified torque.
3) Apply water tight sealant to mating surfaces of brake back
4) Install brake back plate and tighten back plate bolts to speci-
5) For ABS equipped vehicle, check to make sure that ABS wheel
6) Connect brake pipe to wheel cylinder and tighten brake pipe
3. Hose bracket
7) Attach brake hose to strut bracket with E-ring securely.
4. E ring
8) Install wheel hub referring to WHEEL HUB INSTALLATION in
9) Install brake drum referring to BRAKE DRUM INSTALLATION
10) Fill reservoir with brake fluid and bleed brake system. (For
ing rod to knuckle. At this point, temporarily tighten them by
hand.
Tightening Torque
(a): 90 N·m (9.0 kg-m, 65.0 lb-ft)
plate and rear knuckle.
"A": Sealant 99000-31090
fied torque.
Tightening Torque
(b): 50 N·m (5.0 kg-m, 36.0 lb-ft)
speed sensor tooth is free from any metal particles and install
it to knuckle.
flare nut to specified torque and install bleeder plug cap taken
off from pipe back to bleeder plug.
Tightening Torque
(c): 16 N·m (1.6 kg-m, 12.0 lb-ft)
SECTION 3E or 3E1.
of SECTION 5.
bleeding operation, see SECTION 5.)