Suzuki Baleno Manual page 1056

9-56 BODY SERVICE
i) Release locking of lock lever.
ii) After unlocked, disconnect connector.
1. Seat belt pretensioner connector
REMOVAL
1) Disconnect negative battery cable from battery.
2) Disable air bag system. Refer to "DISABLING AIR BAG SYS-
TEM" in Section 9J.
3) Disconnect Yellow connector for seat belt pretensioner.
4) Remove front seat belts with pretensioner from the vehicle re-
ferring to "SEAT BELTS" in this section.
INSPECTION
When checking seat belt with pretensioner, use the following check
items in addition to those specified for seat belt without pretension-
er referring to "SEAT BELTS" in this section.
WARNING:
Never measure resistance of pretensioner or disas-
semble it. Otherwise, personal injury may result.
CAUTION:
If seat belt pretensioner (retractor assembly) was
dropped from a height of 91.4 cm (3 ft) or more, it should
be replaced.
Check retractor assembly with seat belt pretensioner appearance
visually for following symptoms and if any one of them is applica-
ble, replace it with a new one as an assembly.
Pretensioner has activated.
There is a crack in seat belt pretensioner (retractor assembly).
Wire harness or connector is damaged.
Seat belt pretensioner (retractor assembly) is damaged or a
strong impact (e.g., dropping) was applied to it.