Suzuki Baleno Manual page 448

1. ABS hydraulic unit /
control module assembly
2. Nut
1. To right-front 5. From master cylinder
2. To left-rear (secondary)
3. To right-rear 6. From master cylinder
4. To left-front (primary)
4) Remove three nuts and take out ABS hydraulic unit/control
module assembly from bracket.
CAUTION:
D Do not give an impact to hydraulic unit.
D Use care not to allow dust to enter hydraulic unit.
D Do not place hydraulic unit on its side or upside
down. Handling it in inappropriate way will affect its
original performance.
INSTALLATION
1) Install hydraulic unit by reversing removal procedure.
Tightening Torque
.
(a): 16 N m (1.6 kg-m, 12.0 lb-ft)
.
(b): 11 N m (1.1 kg-m, 8.0 lb-ft)
.
(c): 23 N m (2.3 kg-m, 17.0 lb-ft)
2) Bleed air from brake system referring to Section 5.
3) Check each installed part for fluid leakage and perform hydrau-
lic unit operation check.
NOTE:
For new ABS hydraulic unit/control module assembly, it
"ABS HYDRAULIC UNIT OPERATION CHECK" procedure
has not been performed, "ABS" warning lamp may flash
when ignition switch is turned ON position.
Accordingly preform "ABS HYDRAULIC UNIT OPERATION
CHECK" to stop flashing of ABS warning lamp.
ANTILOCK BRAKE SYSTEM (ABS) 5B-33