Suzuki Baleno Manual page 998

1. Data link connector (DLC)
1. Ignition key with built-in transponder
IMMOBILIZER CONTROL SYSTEM (IF EQUIPPED) 8G-33
HOW TO REGISTER IGNITION KEY
Register the ignition key with a built-in transponder in Immobilizer
Control Module by using the following procedure.
1) Prepare Suzuki scan tool (TECH 1A kit and cartridge for immo-
bilizer control system).
2) With ignition switch OFF, connect Suzuki scan tool to data link
connector (DLC) located on underside of instrument panel at
driver's seat side.
Special Tool
(A): 09931-76011 (Tech 1A)
(B): Immobilizer cartridge
(C): 09931-76030 (16/14-pin DLC cable)
NOTE:
For operation procedure of Suzuki scan tool, refer to Suzu-
ki scan tool operator's manual.
3) Prepare ignition key with a built-in transponder. And then turn
ignition switch ON by using it.
4) Number of Transponder codes for ignition key with a built-in
transponder that can be registered in Immobilizer Control Mod-
ule is limited to 4. If needed, clear all Transponder codes for igni-
tion key with a built-in transponder that have been registered in
Immobilizer Control Module by executing the "CLR. TRANS
COD (CLEAR TP CODE)" command in the SELECT MODE
menu by using Suzuki scan tool.
NOTE:
When "CLR. TRANS COD (CLEAR TP CODE)" command is
executed with the malfunction indicator lamp (for vehicles
not equipped with the immobilizer indicator lamp) ON or
the immobilizer indicator lamp ON, it remains ON even after
execution of that command is over. It will start flashing
when the ignition switch is turned OFF once and then
turned ON after some seconds.
5) Using Suzuki scan tool, register Transponder code in Immobi-
lizer Control Module by executing "ENT. TRANS COD (ENT. TP
CODE)" command in SELECT MODE menu.
6) [Vehicle not equipped with immobilizer indicator lamp]
Make sure that malfunction indicator lamp lights when ignition
switch is turned OFF once and then ON.
[Vehicle equipped with immobilizer indicator lamp]
Make sure that immobilizer indicator lamp lights when ignition
switch is turned OFF once and then ON.