Suzuki Baleno Manual page 894

7F-16 REAR DIFFERENTIAL
TOOTH CONTACT PATTERN
1. Differential carrier
2. Breather plug
3. Breather cover
4. Breather bolt
1. Caulking tool
2. Flange nut
DIAGNOSIS AND REMEDY
If adjustment is impossible, replace differential carrier.
D Drive bevel gear or drive bevel pinion defective.
D Poor squareness of differential carrier.
D Differential carrier surface where gear is installed is defective.
Replace defective part as an assembly.
1. Check seating of bevel gear or differential case.
(Check bevel gear for runout).
2. If adjustment is impossible, replace drive bevel gear and pin-
ion as a set or differential carrier.
Replace drive bevel gear and pinion as a set or differential case,
if found defective.
9) Upon completion of gear tooth contact check in Step 8), after
applying sealant to breather cover, install breather plug to rear
cover.
10) After applying sealant to rear cover, install rear cover to differ-
ential carrier.
"A": Sealant 99000-31110
Tightening Torque
(b): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
Tightening Torque for rear cover bolts
(c): 23 N·m (2.3 kg-m, 17.0 lb-ft)
11) Caulk flange nut with caulking tool and hammer.