Suzuki Baleno Manual page 1019

1. Molding
2. Blank
3. Glass
4. Glass spacer
9) Using new brush, apply sufficient amount of primer for glass
along glass surface to be adhered to body.
NOTE:
Be sure to refer to maker's instruction for proper han-
dling and drying time.
Do not touch primer coated surface.
Width "b": Approximately 15 mm (0.59 in.)
1. Molding
10) Using new brush, apply sufficient amount of primer for molding
(Urethane) to surface "A" as shown in figure.
NOTE:
Be sure to refer to maker's instruction for proper han-
dling and drying time.
Do not touch primer coated surface.
11) Apply adhesive referring to figure.
NOTE:
Start from bottom side of glass.
Be careful not to damage primer.
Height of adhesive applied to lower side should be
higher than that of other three sides.
Upper, right and left sides
Width "e"
Height "f"
Lower side
Distance "g" : Approximately 11 mm (0.43 in.)
Width "h"
Height "i"
Press glass against body quickly after adhesive is ap-
plied.
Use of rubber sucker grip is helpful to hold and carry
glass after adhesive is applied.
1. Molding
2. Blank
3. Adhesive
4. Glass
5. Glass spacer
"c": Approximately 13 mm (0.51 in.)
"d": Approximately 27 mm (1.06 in.)
: Approximately 11 mm (0.43 in.)
: Approximately 17 mm (0.67 in.)
: Approximately 12 mm (0.47 in.)
: Approximately 24 mm (0.94 in.)
BODY SERVICE 9-19