Suzuki Baleno Manual page 229

3E-6 REAR SUSPENSION (2WD VEHICLE)
A: Upper side (small diam.)
B: Lower side (large diam.)
1. Strut lower seat
2. Coil spring lower seat
1. Upper seat
2. Spring (rubber) seat
1. Spring upper seat
2. Strut bracket
ASSEMBLY
1) Compress spring with special tool (A) until total length becomes
2) Install coil spring lower seat and compressing coil spring, mate
3) Install bump stopper onto strut rod. For installing direction, refer
4) Instal dust cover onto bump stopper.
5) Fit coil spring (rubber) seat in coil spring upper seat, making
6) Pull strut rod as far up as possible and use care not to allow it
7) With "OUT" mark on spring upper seat and the center of strut
3. "OUT" mark
about 290 mm (11.42 in.) as shown.
Length "a": 290 mm (11.42 in.)
large-dia. spring end with stepped part of lower seat as shown.
to above figure in DISASSEMBLY.
sure that their depth matches all around. No part of rubber seat
should stick out higher than upper seat.
to retract into strut.
bracket aligned, place upper spring seat together with spring
(rubber) seat on coil spring.