Remove And Install Suspension Frame - Suzuki Baleno Manual

3D-18 FRONT SUSPENSION
REMOVE AND INSTALL SUSPENSION
FRAME
REMOVAL
1) Hoist vehicle and remove wheels (right & left).
2) Remove stabilizer bar. Refer to Step 1) – 3) in STABILIZER BAR
REMOVAL of this section.
3) Remove suspension arms (right & left). Refer to Step 3) – 6) in
SUSPENSION ARM REMOVAL of this section.
4) Remove engine rear mounting nuts and engine mounting mem-
1. Suspension
frame
ber bolts (2WD vehicle) or torque bush nuts (4WD vehicle).
2. Engine rear
mounting
NOTE:
3. Mounting
member
D For 2WD vehicle, be careful not to loose cushions and
4. Spacer
spacers which may stick to suspension frame.
5. Cushion
D For 4WD vehicle, support transmission to prevent joint
parts from being applied excessive force at removal of
suspension frame.
5) Remove suspension frame from body.
1. Stabilizer bar
2. Suspension arm (Left)
3. Suspension arm (Right)
4. Engine rear mounting
5. Mounting member-2WD
vehicle only
6. Suspension frame
7. Washer
2WD vehicle
8. Cushion
only
9. Spacer
10. Engine rear torque
bush-4WD vehicle only