Remove And Install Caliper Assembly - Suzuki Baleno Manual

5-38 BRAKES
REMOVE AND INSTALL CALIPER
ASSEMBLY
REMOVAL
1) Hoist vehicle and remove wheel.
2) Remove brake flexible hose mounting bolt from caliper. As this
will allow fluid to flow out of hose, have a container ready before-
hand.
1. Caliper
2. Flexible hose
3. Hose mounting bolt
4. Wire hook
5. Container
3) Remove caliper pin bolts.
4) Remove caliper from carrier.
INSTALLATION
1) Install caliper to caliper carrier.
2) Torque caliper pin bolts to specification.
NOTE:
Make sure that boots are fit into groove securely.
Tightening Torque
(a): 22 N
1. Caliper pin bolts
3) Install brake flexible hose as shown and torque hose mounting
bolt to specification.
Tightening Torque
(b): 23 N
4) Torque wheel nuts to specification. (Refer to "TORQUE SPEC-
IFICATION" in this section.)
5) After completing installation, fill reservoir with brake fluid and
bleed brake system. Perform brake test and check each
installed part for oil leakage.
.
m (2.2 kg-m, 16.0 lb-ft)
.
m (2.3 kg-m, 17.0 lb-ft)