Suzuki Baleno Manual page 402

1. Power steering pump
2. High pressure hose
3. Throttle body
3) Detach power steering pump high pressure hose from power
steering pump. As fluid flows out of disconnected joint, have a
container under joint or plug the hose.
4) Remove throttle body. Refer to "THROTTLE BODY AND IN-
TAKE MANIFOLD" in Section 6A3.
5) Detach booster vacuum hose from booster.
6) Disconnect push rod clevis from brake pedal arm.
7) Remove attaching nuts and then remove booster.
WARNING:
Never disassemble booster assembly. If it is found
faulty, replace it with new assembly.
1. Steering column
2. Push rod clevis
3. Brake pedal arm
4. Clevis pin
5. Cotter pin
6. Nut
[Other than 1.8L engine RH model]
1) Remove master cylinder assembly, referring to "MASTER CYL-
INDER REPAIR" in this section.
2) Disconnect vacuum hose from booster and remove EVAP can-
ister bracket.
3) Disconnect push rod clevis pin from brake pedal arm.
4) Remove attaching nuts and then booster.
CAUTION:
Never disassemble brake booster. Disassembly will
spoil its original function. If faulty condition is found,
replace it with new one.
INSTALLATION
NOTE:
D See NOTE at the beginning of this section.
D Check length of push rod clevis.
D Before installing master cylinder, check booster piston rod
by referring to "INSPECT/ADJUST CLEARANCE BETWEEN
BOOSTER PISTON ROD AND MASTER CYLINDER PIS-
TON" under "BRAKE BOOSTER INSPECTION AND AD-
JUSTMENT" in this section.
D Apply silicone grease to booster push rod seal and master
cylinder piston.
BRAKES 5-77