Suzuki Baleno Manual page 666

7B-96 AUTOMATIC TRANSMISSION (3 A/T)
1. Rear cover
2. Nut
6) Install reduction driven gear on countershaft.
i) Shift manual shift lever to P position so that output shaft is
locked and cannot turn.
ii) Tighten driven gear nut to specification.
CAUTION:
D Tighten nut by turning wrench by hand.
D Tightening nut by hammering wrench may
cause damage to parking lock pawl, output shaft
and reduction gear.
Tightening Torque
(c): 130 N·m (13.0 kg-m, 94.0 lb-ft)
iii) Using a chisel and a hammer, caulk driven gear nut at 2
places.
7) Install transmission rear cover.
i) Install rear cover gasket.
ii) Install rear cover.
Check that output shaft bearing enters to rear cover bearing
hole smoothly.
iii) Install 10 bolts and 2 nuts.
Torque bolts and nuts to the following specifications.
NOTE:
Check to make sure that the shafts rotate smoothly with-
out abnormal noise.
Tightening Torque
(d): 20 N·m (2.0 kg-m, 14.5 lb-ft)
(e): 13 N·m (1.3 kg-m, 9.5 lb-ft)