Suzuki Baleno Manual page 589

1. Data link connector (DLC)
DIAGNOSTIC TROUBLE CODE(S) CLEARANCE
[Using SUZUKI scan tool]
1) Turn ignition switch OFF.
2) After setting cartridge to SUZUKI scan tool, connect it to data
link connector (DLC) located on underside of instrument panel
at driver's seat side.
Special Tool
(A): 09931-76011 (SUZUKI scan tool)
(B): Mass storage cartridge
(C): 09931-76030 (16/14 pin DLC cable)
3) Turn ignition switch ON.
4) Erase DTC according to instructions displayed on SUZUKI
scan tool. Refer to SUZUKI scan tool operator's manual for fur-
ther details.
5) After completing the check, turn ignition switch OFF and discon-
nect SUZUKI scan tool from data link connector (DLC).
[Not using SUZUKI scan tool]
1) Turn ignition switch OFF.
2) Disconnect battery negative cable for specified time below to
erase diagnostic trouble code stored in PCM memory and re-
connect it.
TIME REQUIRED TO ERASE DTC
AMBIENT
TEMPERATURE
Over 0_C (32_F)
Under 0_C (32_F)
AUTOMATIC TRANSMISSION (3 A/T) 7B-19
TIME TO CUT POWER TO PCM
60 sec. or longer
Not specifiable.
Select a place with higher than
0_C (32_F) temperature.