Suzuki Baleno Manual page 559

1. Gear shift locating bolt
2. Low speed locating spring
3. Steel ball
4. High speed locating spring
5. 5th & reverse locating spring
1. Bolt
2. Left case plate
3. Input shaft
4. 5th & REV gear shift guide shaft
5. Countershaft
5) Check locating springs for deterioration and replace with new
ones as necessary.
6) Install steel ball and locating spring for respective gear shift
shaft and tighten with bolt.
Tightening Torque
(a): 13 N·m (1.3 kg-m, 9.5 lb-ft)
FIFTH GEARS
1) For installation procedure, refer to Steps 1) to 3) of same item
in Section 7A.
2) Place left case plate inserting its end in groove of shift guide
shaft and then tighten it with bolts applied with thread lock ce-
ment.
NOTE:
After tightening bolts, make sure that countershaft can be
rotated by hand feeling some load.
"A": Thread lock 1322, 99000-32110
Tightening Torque
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
3) Install countershaft 5th gear to countershaft facing machined
boss A inward.
1. Countershaft 5th
gear
A: Machined boss
(Inside)
B: No maching
(Outside)
REF No.
Locating spring
(Left
free length
figure)
2 Low speed
4 High speed
5 5th & reverse
MANUAL TRANSMISSION 7A2-37
Service
Standard
limit
53.1 mm 50.5 mm
(2.091 in.) (1.988 in.)
46.1 mm 44.0 mm
(1.815 in.) (1.732 in.)
29.8 mm 28.5 mm
(1.173 in.) (1.122 in.)