Rear Brake Pad Lining Inspection; Brake Pedal Play Inspection - Suzuki Baleno Manual

REAR BRAKE DISC INSPECTION
Refer to "REAR DISC BRAKE INSPECTION" in this section for in-
spection point and procedure.

REAR BRAKE PAD LINING INSPECTION

Inspect pad linings periodically according to maintenance sched-
ule whenever wheels are removed (for tire rotation or other rea-
son). Take a look through the hole of caliper and check lining
thickness of outside and inside pads.
If lining is worn and its thickness ("d" in figure) is less than limit, all
pads must be replaced at the same time.
Thickness "d"
Service limit: 1.0 mm (0.04 in.)
1. Pad rim
2. Disc
3. Lining

BRAKE PEDAL PLAY INSPECTION

Pedal play should be within specification below.
If out of specification, check stop light switch for proper installation
position and adjust if necessary.
Also check pedal shaft bolt and master cylinder pin installation for
looseness and replace if defective.
Pedal play "f": 1 – 8 mm (0.04 – 0.31 in.)
BRAKES 5-21