Suzuki Baleno Manual page 665

1. Parking lock pawl
2. Lock pawl sleeve
1. Output shaft
vi) Install parking lock pawl.
a. Shift manual shift lever to a position other than P.
b. Install parking lock pawl.
c. Install lock pawl shaft and lock pawl spring, and then,
3) Install 1st-reverse brake piston.
i) Apply fluid to inner and outer seals (O rings) and fit them to
piston. Use new seals.
ii) Insert piston into case in such way that the side with spring
holes comes to the top. Make sure that seals are not twisted
or caught.
iii) Place return spring assembly on piston. Check to make sure
that each spring of return spring assembly is fitted securely
in spring hole in piston.
iv) Push down return spring assembly and install snap ring.
4) Using a special tool (Bearing installer) and a hammer, install
countershaft.
When inserting countershaft into case, check to make sure that
spacer is in such position as shown in figure.
CAUTION:
Do not hammer shaft excessively hard, or snap ring
and case will be damaged.
Special Tool
1. Countershaft
2. Spacer
(A): 09951-76010
5) Install output shaft.
i) Shift manual shift lever to a position other than P.
ii) Using a special tool (Bearing installer) and hammer, install
output shaft.
Special Tool
(A): 09951-76010
AUTOMATIC TRANSMISSION (3 A/T) 7B-95
check to make sure that parking lock pawl moves
smoothly when manual shift lever is moved.