Suzuki Baleno Manual page 165

3C-4 STEERING WHEEL AND COLUMN (NOT EQUIPPED WITH AIR BAG)
1. Steering wheel
2. Steering shaft nut
1. Steering wheel 3. Steering wheel bumper
2. Steering shaft nut 4. Horn harness
1. Pad
ON-VEHICLE SERVICE
STEERING WHEEL
For 3-spoke type
REMOVAL
1) Disconnect negative battery cable.
2) Pull out steering wheel pad, and then remove it by turning it
1. Pad
3) Remove screw of horn harness.
4) Remove steering wheel bumper from Steering wheel.
5) Remove steering shaft nut.
6) Make alignment marks on steering wheel and shaft for a guide
3. Steering wheel bumper
4. Horn harness
7) Remove SteerIng wheel with special tool.
INSTALLATION
1) Install steering wheel bumper to steering wheel.
2) Install screw of horn harness.
3) Install steering wheel onto shaft, aligning alignment marks on
4) Tighten steering shaft nut to specified torque.
5) Install steering wheel pad.
6) Connect battery negative cable.
counterclockwise.
during reinstallation.
Special Tool
(A): 09944-36011
them.
Tightening Torque
(a): 33 N·m (3.3 kg-m, 23.5 lb-ft)