Suzuki Baleno Manual page 208

REMOVE AND INSTALL WHEEL HUB,
WHEEL STUD/WHEEL BEARING OUTSIDE
INNER RACE
REMOVAL
1) Hoist vehicle and remove wheel.
2) Uncalk drive shaft nut.
1. Drive shaft nut
3) Depress foot brake pedal and hold it there. Remove drive shaft
nut.
4) Remove caliper carrier bolts.
5) Remove caliper with carrier.
NOTE:
Hang removed caliper with a wire hook or the like so as to
prevent brake hose from bending and twisting excessively
or being pulled.
Don't operate brake pedal with pads removed.
6) Remove disc screws.
7) Pull brake disc off by using two 8 mm bolts.
8) Pull out wheel hub with special tools (A) and (B).
Special Tools
(A): 09943-17912
(B): 09942-15511
9) Remove hub bolts with copper hammer or hydraulic press.
1. Hammer
2. Hub bolt
FRONT SUSPENSION 3D-9