Suzuki Baleno Manual page 884

7F-6 REAR DIFFERENTIAL
1. Rear cover 2. Breather plug
1. Rod
2. Side bearing outer race
1. Bolt
2. Drive bevel gear 3. Differential side bearing
DISASSEMBLY
1) Remove rear cover.
2) Remove breather plug from rear cover.
3) Remove differential side bearing stopper and then remove dif-
ferential side bearing retainer.
Special Tool
(A): 09923-58520
4) Using some appropriate rod, drive out differential side bearing
outer races.
NOTE:
When driving out differential side bearing outer races, be
very careful not to cause damage to tooth surface of bevel
gear.
5) Remove bevel gear assembly.
3. Bevel gear assembly
6) Remove bevel gear bolts and then remove drive bevel gear.
7) Remove differential side bearings.
8) Drive out differential side pinion shaft pin with special tool and
hammer.
Special Tool
(B): 09922-85811
9) Disassemble differential side gears, pinions, washers and and
shaft in differential case.