Suzuki Baleno Manual page 548

7A2-26 MANUAL TRANSMISSION
1. No.1 bearing 2. Puller
1. Oil seal 2 Output case
3) Drive out No.1 bearing by using puller and press.
Inspection and reassembly
1) Check tooth surface of hub and rotation of bearing and replace
with new one if necessary.
As long as no abnormal condition such as noise exists before
removal, replacement is unnecessary.
2) Drive in No.1 bearing by using special tool and hammer.
Special Tool
(A): 09913-84510
1. No.1 bearing
3) Install snap ring.
4) Drive in No.2 bearing by using special tool and hammer.
Special Tool
(A): 09913-80112
1. Snap ring
2. No.2 bearing
Sub Assembly Service
Output case
1) If oil seal is removed,install new oil seal with grease applied to
oil seal lip by using special tool.
"A": SUZUKI SUPER GREASE A, 99000-25010
Special Tool
(A): 09913-75810
Clearance
"a": 1.0 – 1.5 mm (0.04 – 0.06 in.)