Suzuki Baleno Manual page 505

1. Bolt
2. Gear shift guide case
3. Gear shift interlock bolt
1. Backup lamp switch
1. 5th shift fork plug 3. Circlip
2. Shift guide ball 4. C-ring
1. Plate bolt 3. Countershaft 5th gear
2. Left case plate 4. Gear puller
DISASSEMBLING UNIT
GEAR SHIFT AND SELECT SHAFT ASSEMBLY AND
FIFTH GEARS
1) Remove gear shift interlock bolt and 5th to REV interlock guide
2) Remove gear shift & select shaft assembly.
4. 5th and REV
interlock guide
bolt
3) Remove 9 bolts and take off transmission side cover.
4) Engage gear double meshing to loosen countershaft and input
5) Remove shaft nuts and then hub plate.
6) Remove backup lamp switch.
7) Remove 5th shift fork plug and guide ball.
8) Remove circlip and C-ring.
9) For removal procedure, refer to Step 5) of Fifth Gears of Disas-
10) Remove input shaft 5th gear, needle bearing and then counter
11) Remove bolts and take off left case plate, and then bearing set
12) Remove C-ring of input shaft L bearing.
MANUAL TRANSMISSION (J18 ENGINE MODEL) 7A1-7
bolt from transmission case.
CAUTION:
Care should be taken not to distort side cover when
it is removed from left case.
shaft nuts.
NOTE:
Do not hammer when loosening nuts.
sembling Unit in SECTION 7A.
shaft 5th gear. Gear puller would be necessary if spline fitting
of countershaft 5th gear is tight.
shim.