Suzuki Baleno Manual page 867

1. Operating cylinder 3. Washers
assembly 4. Bolt
2. Attaching bolts 5. Hose
CLUTCH OPERATING CYLINDER
REMOVAL
NOTE:
Do not allow fluid to get on painted surfaces.
1) Clean around reservoir cap and take out fluid with syringe or
such.
2) Disconnect fluid hose from operating cylinder.
3) Remove operating cylinder attaching bolts and operating cylin-
der.
INSTALLATION
1) For air bleeding of master cylinder alone, it must be removed
from vehicle body.
(For procedures of removal and installation of master cylinder
assembly and air bleeding, refer to "CLUTCH MASTER CYL-
INDER" in this section.)
2) Apply small amount of grease to rod tip.
NOTE:
Don't allow any grease to be on boot.
"A": GREASE 99000-25010(SUZUKI SUPER GREASE A)
3) Install clutch operating cylinder and tighten attaching bolts to
specified torque.
Tightening Torque
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
4) Connect clutch fluid hose and tighten bolt to specified torque.
Tightening Torque
(b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
5) Fill reservoir with specified brake fluid and check for fluid leak-
age.
6) After installation, bleed air from system. (Refer to Section 5 for
air bleed procedure.)
7) Check clutch pedal free travel. (Refer to "MAINTENANCE SER-
VICE" in this section.)
CLUTCH (HYDRAULIC TYPE) 7C1-11