Suzuki Baleno Manual page 490

7A-34 MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS)
1. Input shaft
2. L bearing cup
FIFTH GEARS
1) To seat countershaft L bearing cup to bearing cone, tap cup by
using special tool and plastic hammer.
Special Tool
(A): 09913-84510
2) Put a shim on bearing cup provisionally, place straight edge
over it and compress it by hand through straight edge, and then
measure "a" (Clearance between case surface and straight
edge) by using feeler gauge.
Clearance "a": 0.13 – 0.17 mm (0.0051 – 0.0067 in.)
(Shim protrusion)
3) By repeating above step, select a suitable shim which adjusts
clearance "a" to specification and put it on bearing cup.
NOTE:
Insert 0.15 mm (0.0059 in) feeler to know whether or not a
shim fulfills specification quickly.
Available shim
thickness
1. Straightedge
2. Countershaft
3. Bearing set shim
4. Bearing cup
5. Case surface
6. Feeler gauge
0.40, 0.45, 0.50, 0.55, 0.6, 0.65, 0.7,
0.75, 0.8, 0.85, 0.9, 0.95, 1.0, 1.05, 1.1
and 1.15 mm
(0.015, 0.017, 0.019, 0.021, 0.023,
0.025, 0.027, 0.029, 0.031, 0.033,
0.035, 0.037, 0.039, 0.041, 0.043
and 0.045 in)