Suzuki Baleno Manual page 595

DTC P0705/DTC NO.72 TRANSMISSION RANGE SENSOR (SWITCH) CIRCUIT
CIRCUIT DESCRIPTION – Refer to "GENERAL DESCRIPTION" in this section.
DTC DETECTING CONDITION
DTC will set when either condition A or condition B
occurs.
A: No signal is inputted at ignition switch ON.
B: Multiple signals are inputted while running at higher
than specified vehicle speed with gear in 3rd gear of
"D" range.
DTC CONFIRMATION PROCEDURE
WARNING:
D When performing a road test, select a place where there is no traffic or possibility of a traffic acci-
dent and be very careful during testing to avoid occurrence of an accident.
D Road test should be carried out with 2 persons, a driver and a tester, on a level road.
1) Turn ignition switch OFF and then ON.
2) Clear DTC and warm up engine to normal operating temperature.
3) Shift selector lever to each of P, R, N, D, 2 and L ranges and hold it there for longer than 5 seconds each.
4) Check for DTC and if no DTC appears on display, proceed to the next step.
5) Drive vehicle at 40 mile/h, 60 km/h or more in 3rd gear of "D" range for longer than 5 sec.
6) Stop vehicle and check DTC.
MALFUNCTION
D "Br/Y", "W / B", "R/W", "W/R", "Y / R", "Y" or "R/B"
D Transmission range sensor malfunction.
D Select cable maladjusted.
D PCM malfunction.
AUTOMATIC TRANSMISSION (3 A/T) 7B-25
1. PCM
2. Transmission range sensor
3. From ignition switch
4. Shift indicator
5. Backup lamp
6. Terminal arrangement of PCM coupler
POSSIBLE CAUSE
circuit open or short.
NOTE:
*1: For vehicle with WU-TWC
*2: For vehicle without WU-TWC
(Viewed from harness side)