Suzuki Baleno Manual page 579

1. Countershaft gear
2. Output shaft speed sensor
A: Magnetic core end
AUTOMATIC SHIFT DIAGRAM
Automatic shift schedule as a result of shift control is shown below. In case that selector lever is shifted to L range
at a higher than 40 km/h (25 mile/h) speed, 2nd gear is operated and then down shifts to 1st at a speed lower than
that. No up shift is available in L range.
Selector
Throttle Speed
km/h
Full close
mile/h
km/h
Full open
mile/h
OUTPUT SHAFT SPEED SENSOR (A/T VSS)
The output shaft speed sensor consists of a magnetic core with
magnet and coil. It is mounted on transmission case with 0.6 mm
(0.024 in.) air gap between the core end and countershaft gear
tooth.
While the countershaft rotates, magnetic flux is cut by gear tooth
thus a pulse is generated in the sensor coil according to the speed.
And then, the pulse is transmitted to engine control module as
speed signal.
VEHICLE SPEED
D or 2
Gear
1 2
18
11
60
37
AUTOMATIC TRANSMISSION (3 A/T) 7B-9
D
2 3 3 2
30 14
19 9
113 97
70 61
Upshift
Downshift
D or 2
2 1
14
9
40
25
L
2 1
40
25
40
25