Suzuki Baleno Manual page 870

7C1-14 CLUTCH (HYDRAULIC TYPE)
1. Boot 4. Piston spring
2. Push rod 5. Cup retainer
3. Piston assembly 6. Cylinder
1. Piston
NOTE:
Polishing bore of cylinder with anything abrasive is prohib-
ited, as damage to cylinder bore may occur.
Rinse cylinder in clean brake fluid. Shake excess rinsing fluid from
cylinder. Do not use a cloth to dry cylinder, as lint from cloth cannot
be kept away from cylinder bore surfaces.
REASSEMBLY
NOTE:
Before installation, wash each part in specified brake fluid.
1) Assemble piston as shown in the left figure.
2) Apply brake fluid to piston assembly and inside of cylinder.
7. Bleeder
screw
3) Install piston assembly into cylinder. When inserting it, be care-
ful not to cause damage to lip of piston cup.
4) Install boot and push rod.