5-72 BRAKES
1. Stopper bolt
2. Compressed air
1. Long hole in secondary piston
2. Stopper bolt hole
1. Rod
2. Circlip
DISASSEMBLY
1) Remove circlip.
2) Remove primary piston.
1. Circlip
2. Master cylinder
3) Remove piston stopper bolt. Then remove secondary piston by
blowing compressed air into hole from which piston stopper bolt
was removed.
Be cautious during removal as secondary piston jumps out.
ASSEMBLY
NOTE:
D See NOTE at the beginning of this section.
D Before assembling, wash each part in fluid recommended
to use for that vehicle.
1) Assemble secondary piston as shown on previous page.
2) Install secondary piston assembly into cylinder.
NOTE:
For vehicles equipped with ABS, align long hole in second-
ary piston with stopper bolt hole in master cylinder body
when installing it.
3) Install primary piston assembly into cylinder.
4) Depress, and install circlip.