Suzuki Baleno Manual page 952

1. To power door lock controller (Unlock)
2. To power door lock controller (Lock)
3. To IG switch
5. To door switch
6. To GND
8. To battery
CODE REGISTRATION PROCEDURE
1) Start of code registration
(Initial conditions: IG switch OFF, all doors closed)
2) Open the door and then turn ON the IG switch within 10 se-
conds.
3) Turn OFF the IG switch within 10 seconds after it is turned ON.
4) Turn the door switch ON and OFF 3 times within 20 seconds af-
ter the IG switch is turned OFF.
5) Within 10 seconds after the door switch is turned ON, turn ON
the IG switch and then OFF within next 10 seconds.
6) After LOCK and UNLOCK operation once, the registration
mode is set.
7) Press the UNLOCK button of the transmitter once within 60 se-
conds after the registration mode is set.
8) LOCK and UNLOCK operation once again completes the regis-
tration procedure.
NOTE:
D Perform the above procedure to register a code.
D Two codes can be registered.
D When a new code is registered, the oldest one will be
cleared.
RECEIVER
INSPECTION
Using a tester, check for continuity and voltage between each ter-
minal of the connector connected to the receiver and the body
ground at the following condition.
Terminal Check for
Unlock the driver's seat side door
1 Continuity
by using the key.
Lock the driver's seat side door
2 Continuity
by using the key.
Insert the ignition key and turn
3 Voltage
ON the ignition switch.
5 Voltage Open any one of all closed doors.
6 Continuity Anytime
8 Voltage Anytime
BODY ELECTRICAL SYSTEM 8-55
Standard
Condition
No continuity
Continuity
No continuity
Continuity
0V 10 – 14v
10 – 14V 0V
Continuity
10 – 14V
value