Suzuki Baleno Manual page 975

8G-10 IMMOBILIZER CONTROL SYSTEM (IF EQUIPPED)
[NOTES ON SYSTEM CIRCUIT INSPECTION]
Refer to "Precautions for Electrical Circuit Service" and "Intermit-
tents and Poor Connection" in Section 0A.
[Precaution after replacing ECM/PCM or Immobilizer
Control Module]
D When ECM/PCM was replaced, including when replaced be-
cause rechecking by using a known-good ECM/PCM was nec-
essary during trouble diagnosis, the ECM/Immobilizer Control
Module code must be registered in ECM/PCM and Immobilizer
Control Module by performing procedure described in "Proce-
dure after ECM/PCM Replacement" Section. If it is not regis-
tered, the engine would not start and accurate trouble diagnosis
would not be assured.
D When Immobilizer Control Module was replaced, including when
replaced because rechecking by using a known-good Immobiliz-
er Control Module was necessary during trouble diagnosis, the
Transponder code and ECM/Immobilizer Control Module code
must be registered in Immobilizer Control Module and ECM/Im-
mobilizer Control Module code in ECM/PCM by performing pro-
cedure described in "Procedure after Immobilizer Control
Module Replacement" Section. If they are not registered, the en-
gine would not start and accurate trouble diagnosis would not be
assured.