Suzuki Baleno Manual page 293

1. Absorber adjusting actuator
2. Actuator coupler
1. Actuator
2. Strut adjusting rod end
1. Absorber control actuator
2. Actuator coupler
INSPECTION
1) Check resistance between each two terminals of actuator cou-
pler.
If check results are as specified, proceed to next operation
check. If not, replace.
2) Apply battery voltage to 2 out of 3 terminals of actuator coupler
as indicated in figure.
Check that actuator rod moves to Soft, Medium and Hard posi-
tions as shown below when battery voltage is applied to differ-
ent terminals.
4. Actuator
5. Soft position
6. Medium position
7. Hard position
8. Battery
9. Actuator rod
À
Á
Â
If found defective, replace actuator.
INSTALLATION
1) Install absorber actuator to top of strut.
Fit actuator rod to strut adjusting rod end securely.
2) Tighten screw to specified torque.
Tightening Torque
(a): 3 N·m (0.3 kg-m, 2.2 lb-ft)
3) Connect actuator coupler.
4) Connect negative (–) cable at battery.
Terminals
1 and 2
2 and 3
3 and 1
CAUTION:
Do not apply battery voltage to actuator for longer
than 0.5 seconds. Applying it for longer than 0.5 se-
conds may cause actuator to burn.
Battery positive Battery negative
terminal
3
1
2
SUSPENSION CONTROL SYSTEM 3G-25
Standard resistance
4.6 – 14W
Actuator rod
terminal position
1 Soft
2 Medium
3 Hard