Suzuki Baleno Manual page 914

10 m (32.8 ft)
1. Screen
X – X: Horizontal center light of headlights
A – A: Vertical center line of left headlight
B – B: Vertical center line of right headlight
2. Vertical aiming gear
3. Horizontal
4. Driver
BULB REPLACEMENT
WARNING:
Don't touch when bulb is hot.
1) Disconnect negative (–) cable at battery.
2) Remove air cleaner box.
3) Disconnect harness from bulb.
4) Remove socket cover and bulb.
1. Bulb
2. Spring 5) Replace bulb and install in reverse removal procedure.
HEADLIGHT AIMING WITH SCREEN
NOTE:
Unless otherwise obligated by local regulations, adjust head-
light aiming according to the following procedure.
Before adjustment, make sure the following.
(1) Place vehicle on a flat surface and blank wall 10 m (32.8 ft)
ahead of headlight surface.
(2) Adjust air pressure of all tires to a specified value respectively.
(3) Move vehicle body up and down by hand.
(4) Carry out with one driver (75 kg, 165 lb) aboard.
ADJUSTMENT
1) Check to see if hot spot (high intensity zone) of each main (low)
beam axis falls as illustrated.
Clearance "H": Approximately 130 mm (5.15 in.)
2) If headlight aiming is not set properly, align it to specification by
adjusting aiming gears.
BODY ELECTRICAL SYSTEM 8-17