Suzuki Baleno Manual page 865

1. Master cylinder
2. Clutch pipe
3. Attaching nut
4. Clevis
5. Clevis pin
6. Flare nut
7. Reservoir cap
CLUTCH MASTER CYLINDER
REMOVAL
1) Clean around reservoir cap and take out fluid with syringe or
such.
2) Remove clevis.
3) Disconnect fluid pipe from master cylinder.
NOTE:
Do not allow fluid to get on painted surfaces.
4) Remove master cylinder attaching nuts.
5) Remove master cylinder assembly and gasket.
INSTALLATION
1. Master cylinder
1) To bleed air from master cylinder itself, tilt it as shown and add
fluid into it.
NOTE:
After bleeding air from master cylinder, plug pipe hole in it
to prevent fluid from spilling out of it till pipe is connected.
2) Install master cylinder assembly and new gasket to body, at-
taching nuts.
NOTE:
Do not reuse gasket.
3) Tighten attaching nuts to specified torque.
Tightening Torque
(a): 13 N·m (1.3 kg-m, 9.5 lb-ft)
4) Connect fluid pipe and tighten flare nut to specified torque.
Tightening Torque
(b): 16 N·m (1.6 kg-m, 11.5 lb-ft)
5) Install clevis and clevis pin.
CLUTCH (HYDRAULIC TYPE) 7C1-9