Suzuki Baleno Manual page 852

1. Input shaft
1. Release shaft
1. Tap (Diameter 16 mm Thread pitch 1.5 mm)
1. Tap
4) Slightly apply grease to input shaft, then join transmission as-
sembly with engine. Refer to p. 7A-15 for remounting proce-
dure.
"A": SUZUKI SUPER GREASE I, 99000-25210
NOTE:
Turn crankshaft a little through flywheel gear while insert-
ing transmission input shaft to clutch disc until splines
mesh.
CLUTCH RELEASE SYSTEM
REMOVAL
1) Remove release arm by loosening its bolt.
2) Take out release bearing by turning release shaft.
3) Unhook return spring by using pliers.
4) Drive out No.2 bush by using special tool and hammer.
Release shaft seal will also be pushed out.
Special Tool
(A): 09922-46010
5) Remove release shaft.
6) Remove release shaft No.1 bush.
7) Leaving tap in No. 1 bush, screw in joint pipe over tap, join slid-
ing shaft with joint pipe, and then drive out bush.
Special Tool
(B): 09923-46020
(C): 09930-30104
CLUTCH (CABLE TYPE) 7C-9