Suzuki Baleno Manual page 951

8-54 BODY ELECTRICAL SYSTEM
TROUBLE DIAGNOSIS
Condition
The power door lock func-
tion is available but the
keyless entry function is
not.
Only one power door lock
does not operate.
Operation distance
unstable.
NOTE:
D The operation distance of this system varies depending on the position where the transmitter is oper-
ated, at the front side, the rear side or the lateral side. The distance can be affected by radio noises from
a TV station, a power plant, a broadcasting station and so forth.
D If power door lock does not operate, refer to "POWER DOOR LOCK CONTROL SYSTEM" of the same
section.
Possible Cause
D Fuse blown
D Code registration error
D Transmitter battery dead
D Wiring or grounding faulty
D Receiver faulty
D Transmitter faulty
D Wiring or coupler faulty
D Actuator (door lock motor) faulty
D Transmitter battery dead
D Transmitter faulty
TRANSMITTER
REPLACEMENT OF THE BATTERY
If the transmitter becomes unreliable, replace the battery.
As the battery power is consumed, the operation distance will be
shorter.
1) Put the edge of a coin or a flat blade screw driver in the slot of
the transmitter and pry it open.
2) Replace the battery (lithium disc-type CR2025 or equivalent) so
its
CAUTION:
Use care not to allow grease or dirt to be attached on
the printed circuit board and the battery.
3) Close the transmitter firmly.
4) Make sure the door locks can be operated with the transmitter.
NOTE:
D To prevent theft, be sure to break the transmitter before
discarding it.
D Dispose of the used battery properly according to appli-
cable rules or regulations. Do not dispose of lithium bat-
teries with ordinary household trash.
1. Slot
Replace fuse to check for short.
Register code.
Replace battery.
Repair as necessary.
Replace.
Replace.
Repair as necessary.
Replace.
Replace battery.
Replace.
terminal faces the "+" mark of the transmitter.
Correction