Suzuki Baleno Manual page 720

7B1-36 AUTOMATIC TRANSMISSION
1. TCM
2. Coupler
MANUAL ROAD TEST
This test checks the gears being used in "L", "2" or "D" range when
driven with unoperated gear shift control system. Test drive vehicle
on a level road.
NOTE:
Before this test, check diagnosis code.
1) With select lever in "P", start engine and warm it up.
2) After warming up engine, disconnect couplers of TCM with igni-
tion switch OFF.
3) With select lever in "L" range, start vehicle and accelerate to 20
km/h (12.5 mile/h). Check in this state that 1st gear is being
used.
4) At 20 km/h (12.5 mile/h), shift select lever to 2 range and accel-
erate to 40 km/h (25 mile/h). Check in this state that 3rd gear is
being used.
5) At 40 km/h (25 mile/h), shift select lever to D range and check
that O/D gear is used when speed is higher than 40 km/h (25
mile/h).
6) After above checks, stop vehicle then engine, and connect TCM
coupler with ignition switch OFF.
STALL TEST
This test is to check overall performance of automatic transmission
and engine by measuring stall speed at "D" and "R" ranges. Be sure
to perform this test only when transmission fluid is at normal oper-
ating temperature and its level is between FULL and LOW marks.
CAUTION:
D Do not run engine at stall more than 5 seconds contin-
uously, for fluid temperature may rise excessively
high.
D After performing stall test, be sure to leave engine run-
ning at idle for longer than 30 seconds before another
stall test.
1) Apply parking brake and block wheels.
2) Install tachometer.
3) Start engine with select lever shifted to "P".
4) Depress brake pedal fully.
5) Shift select lever to "D" and depress accelerator pedal fully
while watching tachometer. Read engine rpm quickly when it
has become constant (stall speed).
6) Release accelerator pedal immediately after stall speed is
checked.
7) In the same way, check stall speed in "R" range.
8) Stall speed should be within the following specification.
Stall speed: 2,280 – 2,610 rpm