Suzuki Baleno Manual page 512

7A1-14 MANUAL TRANSMISSION (J18 ENGINE MODEL)
1. Differential side R bearing
2. Differential case
1. Differential side L bearing
2. Differential case
DIFFERENTIAL ASSEMBLY
Disassembly
1) Using special tool, remove R bearing.
Special Tool
(A): 09913-61510
(B): 09925-88210
NOTE:
Change removed bearing to new one.
2) Take out speedometer drive gear.
3) Remove L bearing by using puller while supporting its center
shaft as described above.
4) Support differential case with soft jawed vise and remove final
gear bolts then take out final gear.
5) For disassembly procedure, refer to Step 5) of same item of Sub
Assembly Service in SECTION 7A.
Adjustment and Reassembly
Judging from abnormality noted before disassembly and what is
found through visual check of component parts after disassembly,
prepare replacing parts and proceed to reassembly. Make sure that
all parts are clean.
1) For adjustment and reassembly procedure, refer to Steps 1)
and 2) of same item of Sub Assembly Service in SECTION 7A.
2) Drive in spring pin from right side till it is flush with differential
case surface.
3) Press-fit L bearing by using special tool and copper hammer.
Special Tool
(A): 09951-76010