Suzuki Baleno Manual page 299

1. Boot
2. Snap ring
1. Cage
2. Bearing puller
DISASSEMBLY (Drive Shaft)
1) Remove boot band of differential side joint.
1. Boot band
2) Slide boot toward the center of shaft and remove snap ring from
outer race, then take shaft out of outer race.
3) Wipe off grease and remove circlip used to fix cage by using
special tool (A).
Special Tool
(A): 09900-06107
1. Circlip
4) Draw away cage by using bearing puller, and remove boot from
shaft.
NOTE:
Do not disassemble wheel side joint (outboard joint). If any
malcondition is found in any joint, replace it as assembly.
FRONT DRIVE SHAFT 4-5