Suzuki Baleno Manual page 1112

9J-12 AIR BAG SYSTEM
1. Contact coil and combination switch assembly
2. To horn
3. Connector to driver air bag (inflator) module
4. Connector to air bag harness
1. Instrument panel
2. Passenger knee bolster panel
CONTACT COIL AND COMBINATION SWITCH AS-
SEMBLY
The contact coil assembly consists of three current carrying coils;
two for the deployment loop and one for the horn circuit. The con-
tact coil assembly is combined with the combination switch assem-
bly and mounted together on the steering column, allowing rotation
of the steering wheel while maintaining continuous contact of the
driver deployment loop to the driver air bag (inflator) module.
"AIR BAG" WARNING LAMP
The "AIR BAG" warning lamp is located in the combination meter
and controlled by SDM.
The "AIR BAG" warning lamp is used in the air bag system to do
the following:
D Verify lamp and SDM operation by flashing six times when the
ignition switch is first turned "ON."
D Warn the vehicle driver of air bag electrical system malfunctions
which could potentially affect the operation of the air bag system.
These malfunctions could result in undeployment in case of a
frontal crash or deployment for conditions less severe than in-
tended.
The "AIR BAG" warning lamp is the key to driver notification of air
bag system malfunctions. For proper lamp operation, refer to the
"AIR BAG DIAGNOSTIC SYSTEM CHECK" in this section.
KNEE BOLSTER
The knee bolster is used to absorb energy and control the forward
movement of front passenger during a frontal crash, by limiting leg
movement.
3. Glove box